Table of Contents
How much length do you need for a staircase?
For most homes, staircase consist of two flight and one landing, generally the length of a flight of stairs is between 9 to 12 feet long. Many code suggest that riser height is about 6″ high, tread width is about 10″ and landing width is about 42″ or 3.5 feet.
How long should a 2×12 stringer be?
cut stringers. The two most common cut-stringer defects that I see are overspanning and overcutting. The minimum recommended size for a deck stair stringer is 2×12, which has a maximum recommended unsupported span of 6 feet.
How long of a board do I need for stair stringer?
Stringers should always be cut from 2x12s. Notching smaller stock doesn’t leave enough wood to safely carry the loads of a stair. When ordering stringers, allow about 14 inches of stringer length for each step.
How do I calculate how many steps I need for stairs?
Determining the Rise You divide the height by 7 inches; if, say, the floor-to-floor distance is 8 feet, 10 inches (or 106 inches), then you’ll need 15 treads (106 divided by 7 equals 15.14). Next, you divide the height by the number of treads (15 into 106), producing the exact tread height (7.06 inches).
How much room do I need for stairs?
A standard staircase occupies 30-square-feet of space above and below the staircase. This is the most common dimension, given an 8-foot ceiling, where the staircase width measures 3-feet (36-inches) and horizontal floor space occupied measures between 9- to 10-feet.
Can I use 2×12 for stair treads?
Stair treads may be made of a single 2×12, but are often made of two decking boards or 2x6s. A stringer is a wide board, usually a 2×12, that runs at an angle from the landing pad to the deck framing and supports the treads. The stair treads should be at least 36 inches wide.
How do you calculate opening stairs?
Stair opening = ((floor thickness + headroom clearance) x stair run) / stair rise. The length of the stair opening is represented by the following equation. Progressively simplifying the equation gives (94 x 140) / 120, then 13,160 / 120, and finally 109.67.
What size stringer for stairs?
In general terms, the length of a stringer for a stairs is 14 inches for every step.
What size lumber should I use for stair stringers?
Stair stringers are cut from 2×12 lumber. For exposed side stringers, use cedar lumber. Make one stringer for each 16 inches of stair width. Allow for light boxes if riser lights will be installed. Stair risers are cut from 2×8 material.
How do you calculate the length of stairs?
To calculate the rise, or height, of a stairway, measure the height from one floor level to the next. Divide that total by 22 cm (8 11/16 inches) to see how many stairs you will need. Multiply the number of stairs by the expected width of each tread or step to determine the run, or the length of the stairway. Building regulations.
How to calculate stair stringer length?
Measure the height from the surface where the stairs will start to the bottom surface that the stairs will connect to.