Table of Contents
How much would a Tiger 2 cost?
Full production ran from mid-1944 to the end of the war. Each Tiger II produced needed 300,000 man hours to manufacture and cost over 800,000 Reichsmark or US$300,000 (equivalent to $4,400,000 in 2020) per vehicle. The vehicle was the costliest German tank to produce at the time.
Are there any Tiger 2 tanks left?
The 68-tonne behemoth is one of only eight King Tiger tanks remaining from the roughly 490 built during World War Two.
Could a Sherman destroy a King Tiger?
Yes and it was about the only way a 75mm Sherman could at any range, A 76 mm Sherman could penetrate the front of a Tiger 1 at about 600 m or less and the sides at most combat ranges if it could get a good straight shot with HVAP which was not issued in the numbers it should have after Normandy.
How much is a Tiger 1 worth?
It was the first Tiger 1 that the British captured, or one of the first. It also featured the rare 650 hp engine. But, if you mean how much did it cost the Germans to build it, then that’s around 800,000 reichmarks or 100,000 US dollars.
How many Tiger 1 tanks still exist?
Compared with the other contemporary German tank guns, the 8.8 cm KwK 36 had superior penetration to the 7.5 cm KwK 40 on the Sturmgeschütz III and Panzer IV but inferior to the 7.5 cm KwK 42 on the Panther tank under ranges of 2,500 metres. At greater ranges, the 8.8 cm KwK 36 was superior in penetration and accuracy.
Can 76mm penetrate Tiger?
In 1944, the U.S. fielded the 76mm M1 high-velocity long-barrel gun which could actually penetrate a Tiger’s armor from the front. The gun had already seen action with U.S. Tank Destroyer Battalions. Mounted on the lightly-armored M18 Hellcat tank destoyer, the 76mm M1 was undoubtedly a threat to the German tanks.
What was the strongest tank in WW2?
Known as the “Panther”, the Panzer V was the mightiest of them all, with incredibly thick and sloped armor to ricochet most enemy shots, as well as a 75mm cannon that packed almost as much of a punch as the legendary Tiger tank’s 88mm cannon.
Was the King Tiger II a good tank?
Tiger I. But given a skilled crew and proper logistics support, the Tiger II was fairly reliable, according to Jentz. The problem was that by the time the King Tiger made its combat debut in Normandy in July 1944, the necessities that Nazi Germany most lacked was trained, experienced tank crews and fuel and logistics support.
How many Tiger IIs were built?
However, the most telling statistic is that while the Soviet Union produced nearly 3,900 IS-2s, Germany built just 492 Tiger IIs. The Soviets built more than 108,000 tanks, and the Americans eighty-eight thousand, because World War II was a contest of production that devoured material at an appalling rate.
What kind of engine does a King Tiger have?
The design had sloping armour, with the frontal armour increased to 150mm thick, and 80mm on the sides. The Königstiger (Bengal Tiger), Tiger II, or King Tiger was powered by a V-12 Maybach HL230 P30. It had an output of 700hp at 300rpm, with 8 forward gears and 4 reverse.
What is the difference between King Tiger I and Tiger I?
Tiger I. The King Tiger had well-sloped armor that was six inches thick on the front hull. Its turret could traverse 360 degrees in nineteen seconds, compared to sixty seconds for the Tiger I, which had theoretically allowed a fast-moving Sherman or T-34 to maneuver behind a Tiger I faster than the German tank’s gun could track it.