How much does it cost to replace a camshaft position actuator solenoid?

The average for Camshaft Position Actuator is $665

Repair Type	Zip	Cost
Camshaft Position Actuator	64713	$315
Camshaft Position Actuator	36202	$2848
Camshaft Position Actuator	52804	$500
Camshaft Position Actuator	19082	$800

How much does it cost to get a camshaft position sensor replaced?

To replace a camshaft position sensor, you can expect to pay anywhere from $95 to $200. Parts alone will run about $25 to $100. Labor costs will be in the range of $70 to $100 for professional replacement. Expect to pay more if you have a luxury vehicle or are having your local car dealership perform the replacement.

How much does it cost to fix a camshaft?

Camshaft Replacement Cost – RepairPal Estimate. Labor costs are estimated between $850 and $1,072 while parts are priced at $459. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.

Is P0010 serious?

How Serious Is Code P0010? – Moderate. This trouble code will not prevent your vehicle from running. However, if left unsolved, this code could cause your vehicle to experience decreased power and fuel economy.

Can I drive with a bad camshaft position sensor?

Yes, it is safe to drive with a bad camshaft sensor. However, the performance of your engine will not be as good and fuel consumption may increase. In some cases, the camshaft may need replacement if there are any other symptoms of failure on this component.

Can I drive with a bad camshaft sensor?

Is a camshaft sensor easy to replace?

It may be easiest to remove and replace the camshaft sensor from under your vehicle, but it can also be done from the top by removing the air filter housing. Oil and corrosion could affect the signal from the sensor to the engine control module.

Is P0010 intake or exhaust?

Code P0010 is triggered when the ECM attempts to adjust the Bank 1 intake camshaft timing by utilizing one of these valves, and it detects an electrical issue in either the circuit going to the valve or the windings of the solenoid in the valve itself.

Is it safe to drive with a bad camshaft sensor?

Is it worth replacing a camshaft?

A camshaft should last as long as the rest of the engine it is normally hydraulic camshaft followers that gum up and start the ticking noise. if you are replacing the camshaft after 100,000 miles or more is fine. but if the engine has done 300,000 miles then it will be more than just the camshaft needing replacement.

Can you drive a car with a broken camshaft?

It depends on the make, model, and engine in your car. If the cam sensor is the only input the ECM uses to fire the spark plugs or fuel injectors; then NO, it won’t run. If the engine starts and runs reasonably well; then you can drive it.