Why is my Maytag refrigerator freezer not getting cold?

If your freezer is not cold, the problem may be caused by a broken condenser fan motor. The condenser fan draws cool air through the condenser and over your freezer’s coils. If this fan is broken, your freezer’s inner temperature will rise, and the compressor will overheat.

How do I reset my Maytag freezer?

To reset the front panel on a Maytag fridge, you can use any combination of these keys:

1. For approximately 8 seconds, simultaneously hold down the power save and lighting buttons.
2. Hold the buttons red/freezer for approximately 8 seconds.
3. For 8 seconds, hold the vacation and quick-freeze buttons simultaneously for.

Why is my freezer running but not cold?

If you hear the compressor motor running and your freezer is still not cooling at all, then there could be a problem with the evaporator or condenser coils. Dirty condenser coils are incapable of dispersing heat well and therefore affect your freezer’s cooling capacity.

How do you fix a refrigerator that is not cooling freezer is working?

Vacuum the coils under or behind the fridge. Clogged coils can cause poor cooling. Check to make sure nothing is stuck in the condenser fan and that it spins freely (models with coils on the back won’t have a fan). To do this, unplug the fridge and pull it out.

How do you fix a Maytag refrigerator that is not cooling?

1. The Refrigerator isn’t cooling or is too warm

1. Adjust the temperature.
2. Check the settings.
3. Check if vents are obstructed.
4. Make sure the icemaker is turned on.
5. Check if the water line is kinked.
6. Make sure water shut-off valves are fully open.
7. Make sure the door is sealed properly.
8. Wipe down the door seal gasket.

How do you put a Maytag refrigerator in diagnostic mode?

Enter the Service Test Mode by performing the following sequence of events.

1. Open the Fresh Food door and press and hold the Door Alarm keypad DoorAlarm .
2. Press and hold Refrigerator Temperature UP keypad .
3. Release the Door Alarm Keypad DoorAlarm and wait 3 seconds.
4. Press the Refrigerator UP Keypad again.

Can a freezer stop working but fridge still works?

Refrigerator not cooling but freezer is fine If your freezer is cold but the refrigerator is warm, it is possible that the parts that cool the refrigerator and freezer are working properly. Instead, the problem may reside in the air that is already getting to the freezer also getting to the refrigerator.

How do you reset Maytag refrigerator?

Press and hold the buttons for 8 to 10 seconds to reset the display. The refrigerator display can be reset by pressing and holding the energy save and lighting button for 10 seconds.

Why is my Maytag refrigerator not cooling?

If the coils are freezing over, it will not allow the refrigerator to cool properly, which could be the reason why the refrigerator is warm. Check for continuity and replace the defrost thermostat if there is power getting to the heater but it will not get hot.

Is Maytag a good refrigerator?

The Maytag brand is usually associated with making great washing machines. But their refrigerator line is no exception. They are some of the most reliable, best quality refrigerators on the market. The Whirlpool Corporation recently acquired the Maytag brand.

Why is my Maytag refrigerator leaking water?

SOURCE: Maytag refrigerator is leaking water. Your freezer has a drain that leads to the exterior drain pan beneath the unit. Occasionally this drain can become clogged resulting in standing water inside your freezer,due to line freeze over.

Why is my Refrigerator not cooling but the freezer is?

A faulty evaporator fan motor can also lead to the refrigerator or freezer not cooling enough. If this motor fails, the unit is no longer able to circulate cold air. This can prevent the refrigerator from cooling, but in some cases, the freezer may still cool down. Fixing the motor helps keep both sides cool.